1. Start preparation and inspection:
1. Check whether the connecting bolts are loose.
2. The solenoid valve of the vibration system is installed in place.
3. Whether the wind road is airtight.
4. Turn on the air source of the vibration system and check the pressure and whether it leaks.
2. Start the vibration system and fan
1. Start the vibration system and observe whether it is normal.
2. Start the motor and observe whether the motor is running normally and whether there is any abnormality.
3. Check whether the wind direction is correct. If the wind direction is not correct, please contact relevant personnel to replace the motor phase sequence.
4. Check again whether the bolts at the joints are loose and whether there is abnormal noise.
5. During operation, always pay attention to the operation of the dust removal fan for abnormal noise.
6. The equipment can only operate after the dust removal fan runs for 5 minutes.